If your motor car or vehicle’s engine management system light is on, we can plug in our engine diagnostics tool and run the AutoData software to find out what the issue or problem is with the vehicle, and fix it.
First of all, we would plug in our engine management diagnostics tool into the car and into our laptop to get the specific error codes and information from the engine control unit (ECU). Then, we use our Auto Data software and diagnose exactly what the problem is with the car or vehicle using this information.
Our engine management diagnostics tool and software will work on any make or model of car, from Ford to BMW, Audi, Volkswagen, Nissan, Citreon, Mercedes, Toyota, Vauxhall, etc..
ABS Warning Light
On vehicles equipped with antilock brakes (ABS), a second warning light is provided to warn if a problem occurs within the ABS system. The ABS lamp comes on when the ignition is turned on for a bulb check, then goes out after the engine starts. If the ABS warning light remains on or comes on while driving, it indicates a fault has occurred in the ABS system.
What happens next depends on the nature of the fault. On most applications, the ABS system disables itself if the ABS warning light comes on and remains on. This should have no effect on normal braking. Even so, ABS will NOT be available in an emergency situation or when braking on a wet or slick surface.
CAUTION: If the brake warning light also comes on and remains on while the ABS warning light is on, it signals a serious problem. Your vehicle may not be safe to drive. The brakes and ABS system should be inspected immediately to determine the nature of the problem!
If the ABS light comes on momentarily then goes out, the nature of the problem is usually minor and the ABS system usually remains fully operational. Some vehicle manufacturers call this kind of fault a “nonlatching” fault (meaning it isn’t serious enough to disable the ABS system).
Regardless of the type of fault that occurred to trigger the ABS warning lamp, a special “code” is recorded in the ABS module’s memory to aid in diagnosing the problem. On some vehicles this code can be retrieved by putting the ABS system into a special diagnostic mode. The code is then flashed out through the ABS warning lamp. The code number refers to a diagnostic chart in a service manual that must be followed to pinpoint the faulty component. On other applications, a special “scan tool” must be plugged into the vehicle’s diagnostic connector to read out the fault code.
Diagnosing ABS problems requires a fair amount of knowledge and expertise (as well as special equipment in many applications), so this job is best left to a competent professional.
We charge £30 plug in fee for a diagnostic with this machine. This procedure normally takes about 15-20 minutes. Whether it be from the engine management light itself to the ABS light to the air bags or air conditioning, we cover it all with the launch system.
Our mechanics garage is located on Birkhill Farm in Coalburn, Lanark, South Lanarkshire – we’re just off the B7078 between junctions 10 and 11 on the M74 motorway. Please get directions to our garage from the interactive map below, or call us for any help or advice.